Generally 50-100 miles of driving at speeds under 50 miles per hour is suggested. True run-flat tires will give you the ability to get home. A run-flat tire has a stiff sidewall that allows the car to be driven without air in the tire. Several tire stores I called say they don’t deal with compact tires. I am very uneasy about driving a vehicle without a spare, even if these are run-flat tires. I recently purchased a Cadillac XT5 and discovered it has no spare or jack. The Cadillac dealer says a full-size tire won’t fit in the tire well and compact tires which used to be an optional purchase are no longer available. The issue could be an out-of-balance torque converter or even a poor fit between the engine and transmission. If you could find someone with a vibration measuring tool or even an old Reed vibration meter it may help pinpoint the vibration. This can be accomplished with a couple of large radiator hose clamps using them as balancing weights. You could also try balancing the driveshaft while it is in the car. I would look at the drive shaft angle and also put a dial indicator on the drive shaft to see that it is running true. Since the vibration got better after the driveshaft was replaced, I would continue to focus in that area. The driveshaft was replaced with a new one, which did improve the situation, but the vibration is still there.Ī. The engine runs great, and the transmission was rebuilt. In addition, I have had the water pump and fan clutch replaced as well as drive belts and harmonic balancer checked. The tires were checked and are in balance. I’ve had some shops look at the car and they just can’t figure it out. The car has a high-speed vibration at 40 mph and 70 mph. I have an older rear-wheel drive car with a V-8 engine and automatic transmission. There’s no such thing as a silly question. If the carpets are still damp, leave the doors open for a bit or even put a fan in the car to dry out the interior. Once you are satisfied that the carpets are clean, vacuum with a wet/dry vacuum. You don’t want to get the rugs too wet, just damp. As a DIY approach, mix up some water and dish detergent and then use the suds and a scrub brush. The soap and water loosen up the dirt and stains, and the vacuum extractor pulls out the water.
#Just dial data extractor portable
Good detail shops will vacuum up the loose dirt and debris and then use a portable carpet cleaner. There are times you need to use a shampooer and extractor to get the carpets clean.
0 kommentar(er)
